Video:SetEDID

Last updated 5 August 2026

Video:SetEDID enables you to change your Video output edids,

this allows smooth playback of movies with different Framerates

from a single videoserver especially with 3D movies where

frameblending is not an option.

Pin Info

Pin	Info
`Input 1: Select Sequence [ResourceId, String]` `Input 2: Set Framerate [Float]`	1-Select Sequence[RID]: Sets the referenced Sequenceof the Node using the RecourceID. 1-Select Sequence[String]: Sets the referenced Sequenceof the Node using the Sequence Name. 2-Set Framerate[Float]: Sets the Framerate of the Node andif a matching file is found, all outputs are set to this EDID.
`Output 1: Done [Bang]` `Output 2: Feedback [String]`	1-Done[Bang]: Emits a Bang when all Outputs are set to the selected EDID. 2-Feedback[String]: Emits the Node Status in the following format:"EDID:[x] Display(s) set to [y]FPS" on success or "EDID:Could not execute Powershell" on a Fail."EDID:File used=No File for Framerate found" if no matching file was found.

Input 1: Select Sequence [ResourceId, String]

Input 2: Set Framerate [Float]

1-Select Sequence[RID]: Sets the referenced Sequence*of the Node using the RecourceID.

1-Select Sequence[String]: Sets the referenced Sequence*of the Node using the Sequence Name.

2-Set Framerate[Float]: Sets the Framerate of the Node andif a matching file is found, all outputs are set to this EDID.

Output 1: Done [Bang]

Output 2: Feedback [String]

1-Done[Bang]: Emits a Bang when all Outputs are set to the selected EDID.

2-Feedback[String]: Emits the Node Status in the following format:"EDID:[x] Display(s) set to [y]FPS" on success or "EDID:Could not execute Powershell" on a Fail."EDID:File used=No File for Framerate found" if no matching file was found.